Description

Key Features


  • Supports KCAM4, MACH 2/3, NINOS, etc…
  • Resolution 1, 1/2, 1/8, 1/16 micro stepping output.
  • Suitable for 4, 6, or 8 wire motors.
  • Only a single power needed: control parts and drive parts share one power, you don’t need any more power.
  • Absolute Maximum Ratings: 3.5 amps(peak) /phase motor output, Rated voltage: DC12-DC30V.
  • Current adjustable at 100%, 75%, 50%, 20% of full current by on-board switch.
  • Limit/Home Signal input.
  • Manual Control circuit included.
  • Built-in overheat protection circuit: Thermal shutdown (TSD).
  • Protect the computer by using the isolating power(1000V DCDC) and the optoelectronic coupler, the drive board are separated from the computer.
  • Fixed in a Aluminum box has better cooling function than fan and safer protection for board.

General Specification


  • Voltage Selection:
    a. 12-16V DC power supply for Nema 17 stepper motors
    b. 16-24V DC power supply for Nema 23 stepper motors
    c. 24-30V DC power supply for Nema 34 stepper motors
  • The driver is specially designed for stepper motors with rated current from 0.5A to 3A.
  • Driver output compatible with 2 or 4 phase, and 4,6 or 8 lead stepper motors.

Warning


  • Make sure the power supply voltage dose not exceed the drive’s input range. Double check the connections and make sure the power lead polarity is correct.
  • Do not set high current to small stepper motor. It is possible that the motor will be damaged.
  • Disconnect the motor from the load if you are not sure the move direction. Adjust the axis in the middle before trying to run the motor.
  • Never disconnect the motor lead when the power source is energized.
 
 

Current adjusting and default testing

 

Working Current-->Pause current
S1
S2
S3
S4
20%-->20%
0
0
1
1
50%-->20%
0
1
0
1
75%-->20%
0
0
1
0
75%-->50%
1
0
0
0
100%-->20%
0
1
0
0
100%-->50%
0
0
0
0

i.e. 75%-->20%
Working Current=3.5A x 75%
Pause current=3.5A x 20%

Subdivision surface mode setting

Subdivision
S5
S6
1
1
1
1/2
1
0
1/8
0
0
1/16
0
1

 

Decay mode setting

 

Decay
S7
S8
NO DECAY
1
1
SLOW DECAY
1
0
MID DECAY
0
0
FAST DECAY
0
1

 

What's In Box?

 

  • 1 x 4 Axis TB6560 Stepper Motor Driver
  • 1 x DB25 parallel cable

Write a review

Note: HTML is not translated!
    Bad           Good

4 AXIS STEPPER DRIVER

  • Product Code: 4 axis
  • Availability: Out Of Stock
  • $74.95